User manual is included with individual units.
The ACCUSPLIT Setting Procedure - S1, S2, S3, S4
The ACCUSPLIT Setting Procedure makes it easy to set up any of our products, even if you don't have the instructions handy.
Also known as "S1234" the setting procedure looks complicated at first, but most people really like it once they understand how it works.
Below, we describe how to use the ACCUSPLIT setting procedure. Press the button on the product marked "S1" "S2" "S3" or "S4."
S1 - Enter setting mode (usually 2 second button hold).
S2 - Select the field to be set.
S3 - Change the value of the field being set.
S4 - Exit setting mode (usually 2 - 4 second button hold)
Here's an example:
You have an ACCUSPLIT pedometer and want to set the clock, but have lost the instructions.
1. Find the button labeled "S1." Press and hold the button
for two seconds to enter setting mode. You'll notice that one of the display fields starts to flash, indicating that you are in set mode.
2. Find the button labeled "S2." Repeatedly press the S2 button to cycle through all of the settable fields. Keep pressing the button until you see the clock Hours field start to flash. Now, you are ready to set clock hours.
3. Find the button or buttons labeled "S3." These buttons increase or decrease the value of the field being set. In our example, pressing "S3" will change the Clock Hours value. Some products have two buttons labeled "S3." In that case, if you look more closely, you will see that one button says "S3-" and one says "S3+" S3+ increases the Clock Hours, and S3- decreases the Clock Hours. Set the Clock Hours to the correct time using the S3 button(s).
4. Now, press "S2" to change the field being set to Clock Minutes. It's probably the field right after Clock Hours, so you'll just have to press S2 once. When you stop pushing the buttons, you want to have the Clock Minutes field flashing.
5. With the Clock Minutes field flashing, press the S3 button(s) to adjust the Clock Minutes to show the correct time.
6. You are now done setting the clock. Press and hold the "S4" button for 2-4 seconds to exit setting mode.
You're all finished! See, that wasn't so bad, was it? And, now you know how to set all ACCUSPLIT products, even without having the manual!
